Gaoxin ইন্ডাস্ট্রিয়াল পার্ক, Guangming নতুন জোন, সেন্জ়েং শহর, গুয়াংডং প্রদেশের, চীন | Angelwang66@126.com |
Place of Origin: | China |
পরিচিতিমুলক নাম: | Enargy |
Model Number: | MT13-24S24-PEM |
Minimum Order Quantity: | 1pcs |
---|---|
মূল্য: | Negotiation |
Delivery Time: | 1-8 Weeks |
Payment Terms: | Negotiation |
Supply Ability: | 1000Pcs/week |
লক্ষণীয় করা: | military dc-dc converter,dc to dc converter module |
---|
DC-DC Converters 13W Output 24V MT13-24S24-PEM
Key Features
Output power: 13W
Wide input range:18-36Vdc
High conversion efficiency: 89%
Line regulation to ±0.2%
Load regulation to ±1.0%
Isolation voltage :1,500V
Enable (ON/OFF) control
Output over-current protection
Hiccup mode short circuit protection
Over-temperature protection
Input under-voltage lock-out
Output voltage trim -5~+10 % Vout
Product Overview
These DC-DC converter modules use advanced power processing, control and packaging technologies to provide the performance, flexibility, reliability and cost effectiveness of a mature power component. High frequency Active Clamp switching provides high power density with low noise and high efficiency.
1. Electric Characteristics
1.1 Absolute Maximum Ratings
Parameter | Min | Typ | Max | Units | Notes |
Input Voltage | 45 | Vdc | Continuous, non-operating | ||
36 | Vdc | Continuous, operating | |||
45 | Vdc | Operating transient protection,<100mS | |||
Isolation voltage | 1500 | Vdc | Input to output | ||
Operating Temperature | -55 | 100 | ℃ | In view of PCB Temperature | |
Storage Temperature | -65 | 125 | ℃ | ||
Enable to Vin- Voltage | -0.5 | 10 | Vdc |
1.2 Input Characteristics
Parameter | Min | Typ | Max | Units | Notes |
Input Voltage Range | 18 | 24 | 36 | Vdc | |
Under-Voltage Lockout | 17 | 17.4 | Vdc | Recovery point | |
16 | 16.3 | Vdc | Protect point | ||
Maximum Input Current | 0.9 | A | Input Vin min,Output full load | ||
Efficiency | 88 | % | Rated Input;Rated Load | ||
Dissipation,standby | 0.5 | W | No Load |
1.3 Output Characteristics
Parameter | Min | Typ | Max | Units | Notes |
Output Voltage Set Point | 23.85 | 24.00 | 24.15 | Vdc | Nominal input. No Load |
Output Voltage Range | 23.75 | 24.00 | 24.25 | Vdc | |
Output Current Range | 0 | 0.54 | A | ||
Line Regulation | ±0.02 | ±0.50 | % | ||
Load Regulation | ±0.50 | ±1.00 | % | ||
Current Limit | 0.56 | 0.70 | A | Output voltage 95% of nominal | |
Short Circuit Current | A | ||||
Ripple (RMS) | 40 | mV | Nominal input; full load; 20 MHz bandwidth. | ||
Noise(Peak-to-Peak) | 80 | mV | |||
Maximum Output Cap | 1000 | μF |
1.4 Dynamic Response Characteristics
Parameter | Min | Typ | Max | Units | Notes |
Change In Output Current | 200 | mV | 50% to 75% to 50% Iout max; (di/dt=0.1A/μs). | ||
200 | mV | 50% to 75% to 50% Iout max; (di/dt=0.25A/μs). | |||
Dynamic recovery time | 220 | µS | |||
Turn-on Time | 50 | mS | Starting from vin to vout rise to 90% | ||
Turn-off overshoot | 5 | % |
1.5 Functional Characteristics
Parameter | Min | Typ | Max | Units | Notes |
Switching Frequency | 180 | 200 | 250 | KHz | |
Output Voltage Trim | 10 | % Vout | Trim Up | ||
5 | Trim Down | ||||
Enable Voltage | 0.5 | mA | |||
Enable (ON/OFF) Control Positive Logic |
2.5 | 10 | Vdc | ON-Control, Logic high or floating | |
-0.5 | 1.5 | Vdc | OFF-Control, Logic low | ||
Over-Load Protection | % | Current mode,Pulsecurrent(100% raredload) | |||
Short-Circuit Protection | 100 | mΩ | Hiccup mode,since the recovery | ||
Over-Temperature Protection | 105 | ℃ | Type: Non-Latching, Auto-Recovery;Threshold, PCB Temperature | ||
90 | ℃ | Recovery point |
1.6 Isolation Characteristics
Parameter | Min | Typ | Max | Units | Notes |
Isolation Voltage | 1500 | Vdc | Input to Output | ||
1500 | Vdc | In to base | |||
500 | Vdc | Out to base | |||
Isolation Resistance | 100 | MΩ | At 500VDC to test it when atmosphericpressure and R.H. is 90% | ||
Isolation Capacitance | 1000 | pF |
2. General Characteristics
Parameter | Min | Typ | Max | Units | Notes |
Weight | 30 | Oz (g) | |||
MTBF ( calculated ) | 1 | MHrs | TR-NWT-000332;80% load,300LFM, 40℃ Ta |
3. Environmental Characteristics
Parameter | Min | Typ | Max | Units | Notes |
Operating Temperature | -55 | 100 | ℃ | Base PCB temperature | |
Storage Temperature | -65 | 125 | ℃ | Ambient temperature | |
Temperature Coefficient | ±0.02 | %/℃ | |||
Humidity | 20 | 95 | %R.H. |
4. Standards Compliance
Parameter | Notes |
MIL-STD-704 | |
MIL-STD-1399 | |
MIL-STD-810 | |
UL/cUL60950 | |
EN60950 | |
GB4943 | |
IEC 61000-4-2 |
5. Typical Wave And Curves
Figure 1: Efficiency at nominal output voltage vs.load current for minimum, nominal, and maximuminput voltage at 25°C.
Figure 2: Efficiency at nominal output voltage and60% rated power vs. airflow rate for ambient airtemperatures of 25°C.
Figure 3: Maximum output power derating curves vs.ambient air temperature for airflow rates of 0 LFM through400 LFM with air flowing from pin 3 to pin 1 (nominalinput voltage).
Figure 4: Output voltage ripple at nominal inputvoltage and rated load current (20 mV/div). Loadcapacitance: 0.1μF ceramic capacitor and 10μFtantalum capacitor. Bandwidth: 20 MHz.
Figure 5: Ambient temperature is25 ℃, the load carried by the load(power 13W), the thermal imaging map.
Figure 6: Turn-on transient at full load (resistiveload) (200 ms/div).Input voltage pre-applied.Ch1:ON/OFF Input(2V/div);Ch2:Vout (5V/div)
Figure 7: Shut-down fall time at full load (2ms/div).Ch1:ON/OFF Input(2V/div);Ch2:Vout (5V/div)
Figure 8: Output voltage response to step-change inload current (50%-75%-50% of Iout(max); dI/dt =0.1A/μs). Load cap: 10μF, 100 mΩ ESR tantalumcapacitor and 1μF ceramic capacitor. Ch2:Vout(200mV/div)
Figure 9: Output voltage response to step-change inload current (50%-75%-50% of Iout(max): dI/dt =0.25A/μs). Load cap: 220μF, 30mΩ ESR tantalumcapacitor and 1μF ceramic cap. Ch2: Vout (200mV/div)
6. Physical Information
6.1 Mechanical Outline
Notes:
1. All other pins are 0.6mm dia
2. Pin4 and Pin6 are parallel connection. The user could achieve the function Vout(+) whether connect either two pin orboth.
3. Tolerances: x.xx±0.02 in. (x.x±0.5mm).x.xxx±0.010 in. (x.xx±0.25mm)
6.2 Pin Designations
Pin No. | Name | Function |
1 | Vin(-) | Negative Input voltage |
2 | Enable | TTL input to turn converter on and off, referenced to Vin(-), with internal pull up. |
3 | Vin(+) | Positive Input voltage |
4 | Vout(+) | Positive Output Voltage |
5 | Vout(-) | Negative Output Voltage |
6 | Vout(+) | Positive Output Voltage |
7 | Trim | Output Voltage Trim |
ব্যক্তি যোগাযোগ: Miss. Angel
টেল: 1598940345
ফ্যাক্স: 86-755-3697544
সাধারন সিম নাটক কালো প্লাস্টিক 3FF মাইক্রো, মাইক্রো 500pcs একটি polybag ইন
সেল ফোন জন্য সাধারন সিম অ্যাডাপ্টার স্ট্যান্ডার্ড প্লাস্টিক এবিএস মাইক্রো
সাধারন মোবাইল জন্য স্ট্যান্ডার্ড সিম অ্যাডাপ্টার থেকে গরম বিক্রয় মাইক্রো সিম
প্লাস্টিক এবিএস ন্যানো সিম অ্যাডাপ্টার, আইফোন 4 ন্যানো সিম কার্ড অ্যাডাপ্টারের
ন্যানো 4FF কালো আইফোন 5 ন্যানো সিম নাটক - 3FF
স্বতন্ত্র iPhone5 ন্যানো সিম অ্যাডাপ্টার প্লাস্টিক এবিএস মিনি কার্ডে ন্যানো
4FF - 3FF সিম অ্যাডাপ্টার, সিঙ্গুরের মাইক্রো সিম অ্যাডাপ্টারের 500pcs একটি polybag ইন
প্লাস্টিক এবিএস 3FF মাইক্রো সিম অ্যাডাপ্টার জন্য আইফোন 4 বা আইফোন 5
ন্যানো প্লাস্টিক 2 1 কম্বো মাইক্রো সিম অ্যাডাপ্টারের আইফোন 5 1.2 এক্স 0.9cm জন্য